Steam Powered

该页面认可于2022年12月6日 (星期二)的已复核版本不基于本版本。

	This Page is Written by developer.
	In valid version range, you can trust contents provided by this page.

	This tutorial is written for modpack version 0.4.7.
	As long as the modpack updates, Its contents may be outdated.

Burner

The burner can burn any solid fuel to generate heat. The fuel will be converted into HU and stored in the burner and released to the machine above it according to the limited power rate ~~(gt burner)~~.

The burner has no gui, and the fuel and HU value inside can be seen by wearing goggles, where 10HU=1 steam.

Right-click the burner with the fuel in hand to fill it in, and click it with an empty hand to take out all the fuel inside. You can also use a hopper to automate.

You can stop burning fuel with a redstone signal, but the existing HU will continue to be released.

Advanced burners tend to burn more efficiently, ie. more energy efficient.

If you wear goggles, you can press shift on the burner item to view its parameters.

Standing on it when working cause burn

Boiler

Boilers can receive heat from all directions (but currently only from below since the burner only outputs upwards).

Steam is generated based on input heat and water, water consumption is rounded up, and steam production is generated according to input HU.

The only difference between different boilers is the input power, which means that mismatched combustion chambers can also burn boilers, and there will be nothing wrong ~~(unlike GT boilers will explode)~~, but excess HU will be lose.

In addition, the internal steam storage percentage can be obtained with the redstone comparator, which can be used to design automation.

If the boiler is full, excess steam is vented, emitting steam particles and hissing.

If you wear goggles, you can press shift on the boiler item to view its parameters.

Standing on it when working cause burn.

Steam Engine

The steam engine is the only device that can generate a lot of stress, and the engine must be used with a flywheel of the same class.

Wear goggles to see its working status and steam reserves.

You need a constant supply of steam to make it work, and if the steam supply is sufficient, it will start working properly after a few seconds of preheating. It is recommended to be used with boilers and combustion chambers of the same type.